Skip to main content

Hele- Shaw pump

Left shows the construction and operation of this type of pump which is normally driven by a constant speed electric motor. The pistons are fitted in a row of radial cylinders and through the outer end of each piston is a gudgeon pin , which attaches the slippers to the piston. The slippers are free to oscillate on their gudgeon pins and fit into circular grooves in the circular floating ring . This ring is free to rotate being mounted on ball bearings , which are housed in guide blocks , this reduces oil churning and friction losses. The latter bear on tracks are controlled by the actuating spindles, which passes through the pump casing. The movement of the floating ring by the actuating control spindle (operated by, say, the telemotor receiver) from the central position causes pistons to reciprocate in the radial cylinders so that a pumping action takes place. The direction of the pumping depends upon whether the movement is to the left or right of the central or neutral position.

The action of the pump is shown above.
It should be noted that an advantage with this system is that in reversing the direction of the flow of fluid, the pump moves from maximum delivery in one direction across to zero delivery then through zero delivery to maximum delivery in the opposite direction. The build up in fluid pressure taking place without shock loading of pipe lines supplying fluid to the main steering unit.
The pump is usually provided with an odd number of cylinders, usually seven or nine, which produces more even hydraulic flow and a better balanced pump.

Comments

Popular posts from this blog

Differences between MC/MC-C and ME/ME-C engines

The electrohydraulic control mechanisms of the ME engine replace the following components of the conventional MC engine: Chain drive for camshaft Camshaft with fuel cams, exhaust cams and indicator cams Fuel pump actuating gear, including roller guides and reversing mechanism Conventional fuel pressure booster and VIT system Exhaust valve actuating gear and roller guides Engine driven starting air distributor Electronic governor with actuator Regulating shaft Engine side control console Mechanical cylinder lubricators. The Engine Control System of the ME engine comprises: Control units Hydraulic power supply unit Hydraulic cylinder units, including: Electronically controlled fuel injection, and Electronically controlled exhaust valve activation Electronically controlled starting air valves Electronically controlled auxiliary blowers Integrated electronic governor functions Tacho system Electronically controlled Alpha lubricators

Main engine interlocks

Interlocks are provided so that the engine can be started or reversed only when certain conditions have been fulfilled. When there is a remote control of engines, it is essential to have interlocks. This reduces the possibility of engine damage and any hazards to the operating personnel. Turning gear Interlock . This device prevents the engine from being started if the Turning gear is engaged. Running Direction Interlock . This prevents the fuel from being supplied if the running direction of the engine does not match the Telegraph. Starting Air Distributor in end position . This prevents starting from taking place if the shifting of the Distributor has not been completed. Main Lube. oil pressure, Piston cooling pressure, Jacket water pressure, and important parameters must be above the required minimum. Auxiliary Blower Interlock . The Auxiliary Blower is provided in case of Constant pressure turbo charging. Air Spring pressure Interlock . In case of the present generation

Why is a man hole door elliptical in shape?

Any opening in a pressure vessel is kept to a minimum and for a man entry an elliptical hole  is lesser in size than the corresponding circular hole. More over it is prime concern to have a  smoothed generous radius at the corners to eliminate stress concentration. Hence other  geometrical shapes like rectangle and square are ruled out.  To compensate for the loss of material in the shell due to opening, a doubler ring has to be  provided around the opening. The thickness of the ring depends on the axis length along the  dirrection in which the stresses are maximum and the thickness of the shell. It is important to  align the minor axis along the length of the vessel, as the stress in this direction is  maximum. Longitudinal stress: Pd/2t where P= pressure inside the vessel, d= diameter of the arc, t=  thickness of the shell plating  Circumferential stress: Pd/4t  More over a considerable material and weight saving is achieved as minor is along the  direction of maximum stress.